Jednym z większych wyzwań, przed jakimi stoi polskie leśnictwo, jest opracowanie nowych strategii hodowli lasów w obliczu postępujących zmian klimatu.

Introduction of polymers into the cement composites improves same of the properties of concretes and mortars. Therefore, the polymer-cement composites are successfully used in construction. The model of microstructure formation in cement composites modified with thermoplastic polymer (pre-mix modifiers) has already been developed and successfully implemented. However, the formation of microstructure in the case of epoxy-cement composites (containing post-mix modifier) demonstrates same peculiarities which should be taken into account when modelling the process. The microstructure of epoxy-cement composites and its formation is discussed in the paper. The model is offered, formulated on the basis of the microscopic observations and results of testing.

In order to achieve extended life of asphalt pavement, one of key points is to achieve a good bonding between it’s components. This research paper presents findings on the topic of influence of polyethylene bitumen modification on the adhesion between bitumen and aggregate. A novel method of quantifying the bitumen coated area, based on computer image analysis, has been developed for this study. Two different methods of adhesion testing were employed, namely boiling water method and the rolling bottle method. Aggregates used in this study were granite and limestone. Based on 108 measurements, it was concluded that polyethylene modification has a negative impact on binder aggregate adhesion.

In this study some of the experimental results of water shut-off treatments in oil and gas production wells were presented. The effect of water saturation of Miocene rocks of the Carpathian Foredeep on the relative permeability to gas was analyzed. Also, wide review of the worldwide publications from the point of view of the results obtained in water shut-off treatments in oil and gas formation was presented. Based on experimental results efficiency of relative permeability modification of sandstone from Szydłowiec to brine and nitrogen by four selected chemicals polymers and microgels was evaluated. Experimental results indicated that trend changes of permeability modification strongly depends on the fluid used in the RPM treatment. Moreover, efficiency of permeability modification to brine depends on flow rate of brine through the core - the lower brine flow rate the higher efficiency of the RPM treatment. RPM product number 1 caused significant loss of permeability to brine ca. 60% and slight permeability modification to gas ca. 18%. This permeability change to brine and gas was obtained by modification of formation wettability what affects well productivity. In the case of product number 2 which is based on microgels technology, also significant modification of selective permeability to brine was observed. Loss of permeability to brine was in the range of 65 to 90% while to gas ca. 50%.