Tytuł artykułu

Optimization of Injection Moulding Process via Design of Experiment (DOE) Method based on Rice Husk (RH) Reinforced Low Density Polyethylene (LDPE) Composite Properties

Tytuł czasopisma

Archives of Metallurgy and Materials

Rocznik

2022

Wolumin

vol. 67

Numer

No 2

Autorzy

Jaya, Haliza ; Zulkepli, Nik Noriman ; Omar, Mohd Firdaus ; Abd Rahim, Shayfull Zamree ; Nabiałek, Marcin ; Jeż, Kinga ; Al Bakri Abdullah, Mohd Mustafa

Afiliacje

Jaya, Haliza : Universiti Malaysia Perlis, Centre of Excellence Geopolymer and Green Technology (CeGeoGTech), 02600 Arau, Perlis, Malaysia ; Jaya, Haliza : Universiti Malaysia Perlis (UniMAP), Faculty of Chemical Engineering Technology, Kompleks Pengajian Jejawi 2, 02600 Arau, Perlis, Malaysia ; Zulkepli, Nik Noriman : Universiti Malaysia Perlis, Centre of Excellence Geopolymer and Green Technology (CeGeoGTech), 02600 Arau, Perlis, Malaysia ; Zulkepli, Nik Noriman : Universiti Malaysia Perlis (UniMAP), Faculty of Chemical Engineering Technology, Kompleks Pengajian Jejawi 2, 02600 Arau, Perlis, Malaysia ; Omar, Mohd Firdaus : Universiti Malaysia Perlis, Centre of Excellence Geopolymer and Green Technology (CeGeoGTech), 02600 Arau, Perlis, Malaysia ; Omar, Mohd Firdaus : Universiti Malaysia Perlis (UniMAP), Faculty of Chemical Engineering Technology, Kompleks Pengajian Jejawi 2, 02600 Arau, Perlis, Malaysia ; Abd Rahim, Shayfull Zamree : Universiti Malaysia Perlis, Centre of Excellence Geopolymer and Green Technology (CeGeoGTech), 02600 Arau, Perlis, Malaysia ; Abd Rahim, Shayfull Zamree : Universiti Malaysia Perlis (UniMAP), Faculty of Mechanical Engineering Technology, Kampus Alam Pauh Putra, 02600 Arau, Perlis, Malaysia ; Nabiałek, Marcin : Częstochowa University of Technology, Department of Physics, 42-200 Częstochowa, Poland ; Jeż, Kinga : Częstochowa University of Technology, Department of Physics, 42-200 Częstochowa, Poland ; Al Bakri Abdullah, Mohd Mustafa : Universiti Malaysia Perlis, Centre of Excellence Geopolymer and Green Technology (CeGeoGTech), 02600 Arau, Perlis, Malaysia ; Al Bakri Abdullah, Mohd Mustafa : Universiti Malaysia Perlis (UniMAP), Faculty of Chemical Engineering Technology, Kompleks Pengajian Jejawi 2, 02600 Arau, Perlis, Malaysia

Słowa kluczowe

injection moulding ; Design of Experiments (DOE) ; Central Composite Design ; response surface methodology (RSM) ; shrinkage ; tensile strength

Wydział PAN

Nauki Techniczne

Zakres

719-727

Wydawca

Institute of Metallurgy and Materials Science of Polish Academy of Sciences ; Committee of Materials Engineering and Metallurgy of Polish Academy of Sciences

Data

2022.06.10

Typ

Article

Identyfikator

DOI: 10.24425/amm.2022.137810 ; e-ISSN 2300-1909