TY - JOUR N2 - The article presents the results of research on the finishing of M63 Z4 brass by vibratory machining. Brass alloy was used for the research due to the common use of ammunition elements, cartridge case and good cold forming properties on the construction. Until now, the authors have not met with the results of research to determine the impact of abrasive pastes in container processing. It was found that the additive for container abrasive treatment of abrasive paste causes larger mass losses and faster surface smoothing effects. The treatment was carried out in two stages: in the first stage, the workpieces were deburred and then polished. Considerations were given to the impact of mass of workpieces, machining time and its type on mass loss and changes in the geometric structure of the surface. The surface roughness of machining samples was measured with the Talysurf CCI Lite optical profiler. The suggestions for future research may be to carry out tests using abrasive pastes with a larger granulation of abrasive grains, and to carry out tests for longer processing times and to determine the time after which the parameters of SGP change is unnoticeable. L1 - http://www.czasopisma.pan.pl/Content/113137/PDF/AFE%204_2019_01.pdf L2 - http://www.czasopisma.pan.pl/Content/113137 PY - 2019 IS - No 4 EP - 10 DO - 10.24425/afe.2019.129622 KW - Surface treatment KW - Product development KW - Vibratory machining KW - Surface roughness KW - Brass finishing A1 - Bańkowski, D. A1 - Spadło, S. PB - The Katowice Branch of the Polish Academy of Sciences VL - vol. 19 DA - 2019.09.24 T1 - The Influence of Abrasive Paste on the Effects of Vibratory Machining of Brass SP - 5 UR - http://www.czasopisma.pan.pl/dlibra/publication/edition/113137 T2 - Archives of Foundry Engineering ER -