@ARTICLE{Majerík_Jozef_Analysis_2021, author={Majerík, Jozef and Barényi, Igor and Pokorný, Zdenek and Sedlák, Josef and Neumann, Vlastimil and Dobrocký, David and Jaroš, Aleš and Krbaťa, Michal and Jambor, Jaroslav and Kusenda, Roman and Sagan, Miroslav and Procházka, Jiri}, volume={69}, number={6}, journal={Bulletin of the Polish Academy of Sciences Technical Sciences}, pages={e139203}, howpublished={online}, year={2021}, abstract={This article deals with the effect of selected machining parameter values in hard turning of tested OCHN3MFA steel in terms of SEM microstructural analysis of workpiece material, cutting forces, long-term tests, and SEM observations of flank wear VB and crater wear KT of used changeable coated cemented carbide cutting inserts in the processes of performed experiments. OCHN3MFA steel was selected as an experimental (workpiece) material. The selected experimental steel was analyzed prior to hard turning tests to check the initial microstructure of bulk material and subsurface microstructure after hard turning and chemical composition. Study of workpiece material’s microstructure and worn cemented carbide cutting inserts was performed with Tescan Vega TS 5135 scanning electron microscope (SEM) with the X-Ray microanalyzer Noran Six/300. The chemical composition of workpiece material was analyzed with Tasman Q4 surface analyzer. All hard turning experiments of the used specimens were performed under the selected machining parameters in the SU 50A machine tool with the 8th selected individual geometry of coated cementite carbide cutting inserts clamped in the appropriate DCLNR 2525M12-M type of cutting tool holder. During the hard turning technological process of the individual tested samples made of OCHN3MFA steel, cutting forces were measured with a Kistler 9257B piezoelectric dynamometer, with their subsequent evaluation using Dynoware software. After the long-term testing, other experiments and results were also realized, evaluating the influence of selected machining parameters with different cutting insert geometry on the achieved surface quality.}, type={Article}, title={Analysis of the OCHN3MFA steel in terms of cutting forces and cutting material flank wear mechanisms in hard turning processes}, URL={http://www.czasopisma.pan.pl/Content/121093/PDF/Z_26_02165_Bpast.No.69(6)_OK.pdf}, doi={10.24425/bpasts.2021.139203}, keywords={mechanical properties, microstructural analysis, cutting forces, flank wear, crater wear}, }