@ARTICLE{Pastirčák_R._Influence_2018, author={Pastirčák, R. and Ščury, J. and Brůna, M. and Bolibruchová, D. and Jakubski, J.}, volume={vol. 63}, number={No 4}, journal={Archives of Metallurgy and Materials}, pages={1889-1893}, howpublished={online}, year={2018}, publisher={Institute of Metallurgy and Materials Science of Polish Academy of Sciences}, publisher={Committee of Materials Engineering and Metallurgy of Polish Academy of Sciences}, abstract={The paper deals with squeeze casting technology. For this research a direct squeeze casting method has been chosen. The influence of process parameters variation (casting temperature, mold temperature, pressure) on mechanical properties and structure will be observed. The thicknesses of the individual walls were selected based on the use of preferred numbers and series of preferred numbers (STN ISO 17) with the sequence of 3.15, 4.00, 5.00, 6.00 and 8.00 mm. The width of each wall was 22 mm with a length of 100 mm. As an experimental material was chosen the AlSi12 and AlSi7Mg0.3 alloys. The mechanical properties (UTS, E) for individual casting parameters and their individual areas of different thicknesses were evaluated. In the structure the influence of pressure on the change of the eutectic morphology, the change of the volume of eutectic and the primary alpha phase, the effect of the pressure on the more fine-grain and the regularization of the structure were evaluated.}, type={Artykuły / Articles}, title={Influence of Casting Wall Thickness on Crystallisation Under Pressure}, URL={http://www.czasopisma.pan.pl/Content/109161/PDF/AMM-2018-4-42-Pastircak.pdf}, doi={10.24425/amm.2018.125120}, keywords={Squeeze casting, AlSi7Mg0.3 alloy, AlSi12 alloy, pressure, wall thickness}, }