According to the most popular conceptualization of materialism by Richins and Dawson it consists of three components: acquisition centrality, acquisition as the pursuit of happiness and possession -defined success. They are usually combined and an overall indicator of materialism is used commonly in various studies. In the article the three components are examined separately. Differences in their nature are revealed in a theoretical analysis, whereas in two empirical studies the ways they connect with well -being are presented. The results show that the overall materialism explains much less variance of well -being than the three components taken separately. Of the three the possession-defined happiness is the most detrimental to all aspects of well -being. The possession -defined success does not connect with well -being at all. Finally, acquisition centrality elevates hedonic and psychological well -being. The conclusion is that the modest effect of materialism on well -being, usually identified in various studies, is probably at least partly due to conflicting forces existing within the construct.
Once flourishing in the early medieval India, the materialist Carvaka/Lokayata tradition of philosophy vanished centuries ago leaving mere bits from their foundational sutra, and from a few commentaries thereon. These are scattered in the works of their opponents, hence the winding path to reconstructing the Carvaka/Lokayata thought necessarily begins with evaluating the reliability of the source material. This paper deals with the problem of the brief account of two interpretations of the Carvaka/Lokayata aphorism: 'from these, consciousness', recorded by the 8th-century Buddhist authors Śantarak�ita and Kamalaśfla in the Lokâyata-parfk$a Chapter XXII of the Tattva-sańgraha(-pañjika), critically edited by the author of the present paper.
The paper contains a short literature review on the subject of special type of thin film structures with resistiveswitching memory effect. In the literature, such structures are commonly labeled as "memristors". The word "memristor" originates from two words: "memory" and "resistor". For the first time, the memristor was theoretically described in 1971 by Leon Chua as the 4th fundamental passive electronics element with a non-linear current-voltage behavior. The reported area of potential usage of memristor is enormous. It is predicted that the memristor could find application, for example in the domain of nonvolatile random access memory, flash memory, neuromorphic systems and so forth. However, in spite of the fact that plenty of papers have been published in the subject literature to date, the memristor still behaves as a "mysterious" electronic element. It seems that, one of the important reasons that such structures are not yet in practical use, is unsufficient knowledge of physical phenomena determining occurrence of the switching effect. The present paper contains a literature review of available descriptions of theoretical basis of the memristor structures, used materials, structure configurations and discussion about future prospects and limitations.
A great number of non-functional child care facilities for children up to the age of three have been created in Poland to this day. This state of affairs may be the consequence of the low level of knowledge in this field, as well as few available studies on topics associated with nursery facilities, which may familiarise readers with the legal aspects, administrative procedures, or examples of good functional and material solutions of such units. What is more, there is also little information about the needs and preferences of people directly related to the topic. The aim of the article is to analyse the expectations and preferences of nursery facilities’ users in terms of the functional and material solutions. Based on a survey conducted among the nurseries’ employees and parents placing their children in the care of such institutions, a number of guidelines has been defined, allowing for the design of an optimal nursery facility that would meet the market’s expectations.
The present article investigates theoretically the refection and transmission through a lossless dielectric slab embedded between two semi−infinite left−handed materials (LHMs) in which the electric permittivity and magnetic permeability are simultaneously negative. The LHM is assumed to be dispersive according to Lorentz as well as Drude medium model. The reflection and transmission coefficients are studied with the angle of incidence, frequency and slab thickness. The effect of the damping frequency is also investigated. It is found that the damping frequency has an insignificant effect on reflected, transmitted and loss powers. Band pass filter is one of the possible applications of the proposed structure.
The paper presents brown coal as one of the two basic domestic energy raw materials apart from hard coal. Historically, the use of brown coal in Poland is primarily fuel for the power plants. It was used for the production of lignite briquettes in small quantities and as fuel for local boiler houses and as an addition to the production of fertilizers (Konin and Sieniawa). At present, after changes in the case of the quality of fuels used in local boiler plants, brown coal remains as a fuel for the power plants in almost 100%. Currently, the brown coal industry produces about 35% of the cheapest electricity. The cost of electricity production is more than 30% lower than the second basic fuel – hard coal. The existing fuel and energy complexes using brown coal, with the Bełchatów complex at the forefront, are now an important guarantor of Poland’s energy security. In contrast to the other fuels such as: oil, natural gas or hard coal, the cost of electricity production from brown coal is predictable in the long term and almost insensitive to fluctuations in global commodity and currency markets. Its exploitation is carried out using the high technological solutions and respecting all environmental protection requirements, both in the area of coal extraction and electricity generation. Importantly, the fuel and energy complexes using brown coal showed a positive profitability so far and generated surpluses enabling the financing of maintenance and development investments, also in other energy segments. In particular, the sector did not require and has yet not benefited from public aid in the form of, for example, subsidies or tax concessions. Polish brown coal mining has all the attributes necessary for long-term development to ensure the country’s energy security. The document which is a road map for the brown coal industry is the Program for the Brown Coal Mining Sector in Poland adopted by the Council of Ministers on May 30, 2018. The Program covers the years 2018–2030 with a perspective up to 2050 and presents the development directions of the brown coal mining sector in Poland together with the objectives and actions necessary to achieve them. The Program presents a strategy for the development of brown coal mining in Poland in the first half of the 21st century. Possible scenarios have developed in active mining and energy basins as well as in new regions with significant resources of this mineral. This is to enable the most efficient use of deposits in the Złoczew and Konin regions as well as the Gubin and Legnica brown coal basins, and then deposits located in the Rawicz region (Oczkowice) as well as other prospective areas that may eventually replace the existing active mining and energy areas. This will allow power plants to continue to produce inexpensive and clean electricity, using the latest global solutions in the field of clean coal technologies.
The Legnica deposit is one of the most prospective in the context of future lignite mining. Its extraction will be inseparable from the removal of the rocks of the overburden, the volume of which is very large. Due to the raw material properties, some of the rocks can be classified as accompanying minerals. The raw material identification of overburden sediments in the Legnica lignite deposit is insufficient. So far, they haven’t been the subject of detailed and comprehensive research to prove their usefulness. The article was a summary of the knowledge on this subject. The following should be included in the accompanying minerals: Quaternary sands and gravels, tertiary sands and clays (Poznan clays). They are present in two colour variants in the Legnica deposit - and fiery. The mineral composition of greenish-blue clays allows them to be included in illite-kaolinite- smectite varieties, in turn fiery clays as kaolinite-illite-smectite varieties. The tertiary clays are a very useful raw material for the production of building materials. In addition, they are potential mineral sorbents due to the nature of the association of clay minerals (occurrence of montmorillonite). They also show suitability for building waterproofing barriers. Quaternary gravels and sands, developed in the overburden Legnica deposit are differentiated raw materials. Some of them are raw materials for the construction industry. The glacial tills can be used as a component of ceramic mixtures. Tertiary sands can be used as a proppant material. The information on the raw material properties of these sediments will be one of the essential criteria for their treatment as accompanying minerals. Minerals accompanying those developed in the Legnica deposit should be exploited and deposited selectively. The creation of anthropogenic deposits accumulating these minerals will provide the possibility of their use for decades after the termination of operation.
As of the spring of 2017, the HAŁDY Database is available on the Polish Geological Institute – NRI website. The geodatabase contains information and data on waste mineral raw materials collected on old heaps, industrial waste stock-piles and in post-mining settlers, from the Polish part of the Sudety Mountains. The article presents the types of data and information contained in the geodatabase and the methodology for their collection. As a result of four-year research works, field reconnaissance, archives and geological basic research, 445 objects of former mining and mineral processing were inventoried. There are 403 mine heaps, 16 industrial settlers, 23 stock-piles and 3 external dumps. These are mainly objects after coal mining and metal ores, including post-uranium. The greatest opportunities for the economic use of waste are associated with coal sludge accumulated in settlers of the liquidated Lower Silesian Coal Basin. The material from stone heaps after polymetallic, iron and fluorite ore mining is also easy to use. The issue of the economic use of post-flotation copper ore waste or the recovery of metals (including gold) from dumps of arsenic mining remains open. The limitation here is the efficiency of metal recovery technologies and environmental restrictions. Some of the objects are located in protected areas, which excludes the possibility of waste management. Some stock-piles and heaps should be carefully reclaimed and covered by environmental monitoring, due to their harmful impact on environmental components.
The first Mineral Policy in Poland was prepared in 1938. In that time The Mineral Policy was primarily dedicated to preparing Poland for a defensive war. The Central Geology Authority (CGA) was created in 1991. The main task of this Authority was preparation plans (annual and multiannual) of geological-exploration. The CGA’s activities were focused on enhancing the resource base of mineral deposits. As of 1985 the coordination of geological tasks is the main duty of the Chief Geologist of the country. In 1996 the Council of Ministers adopted a document called State policy in the field of mineral resources, prepared at the Ministry of Environmental Protection, Natural Resources and Forestry as well as the Ministry of Industry and Trade. In 2015 a wide public discussion about the need to develop a mineral raw materials policy, initiated by the publication of three analytical documents prepared by the Demos Foundation, Professor J. Hausner and the Ministry of the Environment took place. Milestones in the development of a national mineral raw materials policy was the establishment of the special government’s plenipotentiary as well as the inter-ministerial team for mineral raw materials policy. In 2018, The Mineral Raw Materials Policy was transferred for public consultation. This document is the first document that is so comprehensive and holistic from the point of view of national mineral security interests. The Mineral Raw Materials Policy is based on 9 substantial pillars among them: economical and legal basis of mineral sector activities, investment risk, geological prospection and exploration, utilization of mineral wastes.
The authors established the chemical and phase compositions of grain fractions of the magnesia carbon scrap disintegrated using industrial cone crushers. The investigations included chemical and XRD analyses and optical investigations. The contents of admixtures: SiO2, CaO, Fe2O3 and Al2O3 increase with the decreasing size of the scrap grain fractions, whereas the C/S ratio decreases in finer and finer fractions due to changes of the phase composition. These relations are caused by the presence of low-fusible silicate phases, characterized by their cleavage and brittleness. Such phases were mainly derived from the graphite ash containing a high silica content. The scrap after removing its finest grain fractions can be recycled and utilized for producing the magnesia-carbon refractory materials. However, the finest grain fractions may be used, e.g. as a component of gunite mixes. Many years of experience collected by the ArcelorMittal Refractories Ltd., Krakow, Poland in the field of refractory scrap utilization has also been presented.
Building a Strategic Battery Value Chain in Europe COM/2019/176 is a priority for EU policy. Europe’s current share of global cell production is only 3%, while Asia has already reached 85%. To ensure a competitive position and independence in the battery market, Europe must act quickly and comprehensively in the field of innovation, research and construction of the infrastructure needed for large-scale battery production. The recycling of used batteries can have a significant role in ensuring EU access to raw materials. In the coming years, a very rapid development of the battery and rechargable battery market is forecast throughout the EU. In the above context, the recycling of used batteries plays an important role not only because of their harmful content and environmental impact, or adverse impact on human health and life, but also the ability to recover many valuable secondary raw materials and combine them in the battery life cycle (Horizon 2010 Work Programme 2018–2020 (European Commission Decision C(2019) 4575 of 2 July 2019)). In Poland, more than 80% of used batteries are disposable batteries, which, together with municipal waste, end up in a landfill and pose a significant threat to the environment. This paper examines scenarios and directions for development of the battery recycling market in Poland based on the analysis of sources of financing, innovations as well as economic and legal changes across the EU and Poland concerning recycling of different types of batteries and rechargable batteries.
Obtaining a pure product by mixing together raw materials, so as to carry out a chemical reaction at high selectivity, is a difficult part of manufacturing chemical products. How can we test reactors and mixers to ensure the efficient use of energy?
Magnetic properties of silicon iron electrical steel are determined by using standardized measurement setups and distinct excitation parameters. Characteristic values for magnetic loss and magnetization are used to select the most appropriate material for its application. This approach is not sufficient, because of the complex material behavior inside electrical machines, which can result in possible discrepancies between estimated and actual machine behavior. The materials’ anisotropy can be one of the problems why simulation and measurement are not in good accordance.With the help of a rotational single sheet tester, the magnetic material can be tested under application relevant field distribution. Thereby, additional effects of hysteresis and anisotropy can be characterized for detailed modelling and simulation.