The paper presents numerical and experimental research on glulam delamination in a double lap connection with predominant shear stresses. Laboratory tests and wide literature survey enabled to determine timber and glue joint parameters. Cohesive zone theory, generally used for epoxy matrix and fiber reinforced composites, was adopted to modelling glue layer delamination in glulam elements. Numerical models were validated with laboratory tests.
This paper presents the results of preliminary tests for estimating the modulus of elasticity of wooden beams from firs reinforced with PBO fiber mesh. The tests were carried out in the Materials Strength Laboratory at the Kielce University of Technology in Kielce, Poland with PN-EN 408:2004. The wooden elements were subjected to a four-point bending test with the aim of estimating the elastic modulus when bending, assuming the loading velocities of the loading forces of 5 mm/min. The obtained results show a significant increase in the load-bearing capacity of beams reinforced with PBO mesh.
In this article, the issue of mining impact on road pavements and subgrade is presented, taking into account the interaction between geosynthetic reinforcement and unbound aggregate layers. Underground mining extraction causes continuous and discontinuous deformations of the pavement subgrade. Structural deformations in the form of ruts are associated with the compaction of granular layers under cyclic loading induced by heavy vehicles. Horizontal tensile strains cause the loosening of the subgrade and base layers. The granular layers under cyclic loading are additionally compacted and the depth of ruts increases. Moreover, tensile strains can cause discontinuous deformations that affect the pavement in the form of cracks and crevices. Discontinuous deformations also affect the pavement in the fault zones during the impact of mining extraction. The use of geosynthetic reinforcement enables the mitigation of the adverse effects of horizontal tensile strains. Horizontal compressive strains can cause surface wrinkling and bumps. Subsidence causes significant changes in the longitudinal and transverse inclination of road surface. Both examples of the laboratory test results of the impact of subgrade horizontal strains on reinforced aggregate layers and the selected example of the impact of mining deformation on road subgrade are presented in this article. The examples show the beneficial impact of the use of geosynthetic reinforcement to stabilize unbound aggregate layers in mining areas.