Wave motion in pipe bends is much more complicated than that in straight pipes, thereby changing considerably the propagation characteristics of guided waves in pipes with bends. Therefore, a better understanding of how guided waves propagate in pipe bends is essential for inspecting pipelines with bends. The interaction between a pipe bend and the most used non-dispersive torsional mode at low frequency in a small-bore pipe is studied in this paper. Experiments are conducted on a magnetostrictive system, and it is observed that T(0,1) bend reflections and mode conversions from T(0,1) to F(1,1) and F(2,1) occur in the pipe bend. The magnitude of the T(0,1) bend reflections increases with increasing propagation distance and excitation frequency. The amplitude of the mode-converted signals also increases with increasing propagation distance, but it decreases with increasing excitation frequency. Because of their longer bent path, the test signals for a pipe bend with a bending angle of 180X are much more complicated than those for one with a bending angle of 90X. Therefore, it is even more difficult to scan a bent pipe with a large bending angle. The present findings provide some insights into how guided waves behave in pipe bends, and they generalize the application of guided-wave inspection in pipelines.

Fouling is inevitable on the surfaces of industrial equipment, especially on heat-exchanging surfaces in contact with fluids, which causes water pollution and destroys the ecological environment. In this paper, a novel fouling-removal methodology for plate structure based on cavitation by multi-frequency ultrasonic guided waves is proposed, which can remove fouling on stainless steel plates. A numerical simulation method has been developed to study the acoustic pressure distribution on a steel plate. According to the simulation results, the distribution of sound pressure on the plate under triple-frequency excitation is denser and more prone to cavitation than in single-frequency cases and dual-frequency cases, which improves fouling removal rate. The stainless steel plate is immersed in water for the descaling experiment, and the results show that the fouling removal rates of three water-loaded stainless steel plates under different single-frequency excitation seem unsatisfactory. However, the multi-frequency excitation improves the descaling performance and the removal rate of fouling reaches 80%. This new method can be applied to the surface descaling of large equipment plates, which is of great significance for purifying water quality and protecting the ecological environment.

On-chip optical-interconnect technology emerges as an attractive approach due to its ultra-large bandwidth and ultra-low power consumption. Silicon-on-insulator (SOI) wire waveguides, on the other hand, have been identified to potentially replace copper wires for intra-chip communication. To take advantage of the wide bandwidth of SOI waveguides, wavelengthdivision multiplexing (WDM) has been implemented. However, WDM have inherent drawbacks. Mode-division multiplexing (MDM) is a viable alternative to WDM in MIMO photonic circuits on SOI as it requires only one carrier wavelength to operate. In this vein, mode converters are key components in on-chip MDM systems. The goal of this paper is to introduce a transverse electric mode converter. The suggested device can convert fundamental transverse electric modes to first-order transverse electric ones and vice versa. It is based on small material perturbation which introduces gradual coupling between different modes. This device is very simple and highly compact; the size of which is 3 μm2. Mathematical expressions for both the insertion loss and crosstalk are derived and optimized for best performance. In addition, three-dimensional finite-difference time-domain (3D-FDTD) simulations are performed in order to verify the mathematical model of the device. Our numerical results reveal that the proposed device has an insertion loss of 1.2 dB and a crosstalk of 10.1 dB. The device’s insertion loss can be decreased to 0.95 dB by adding tapers to its material perturbation.