The paper presents the method of probabilistic optimisation of load bearing capacity and reliability of statically indeterminate bar structures, and of coupling of members in kinematically admissible failure mechanisms (KAFM), which contain minimal critical sets of elements (MCSE). The latter are characterised by the fact that if only a single element is operational, the whole set is operational too. A method of increasing load bearing capacity and reliability of KAFM built from bars dimensioned in accordance with the code is presented. The paper also shows estimation of load bearing capacity and reliability of KAFM of the optimised structures containing elastic-plastic bars with quasi-brittle connections with nodes. The necessity of increasing connection of load bearing capacity and reliability in relation to bar reliability in order to prevent bars from being excluded from MCSE due to connection fracture is estimated.
The paper provides a solution to the problem of dimensioning decisive bars on the basis of the conditions of meeting the recommended reliability classes [9] of statically determinate structures composed of n members. A theorem was formulated:if a statically determinate structure composed of n decisive members is to attain the reliability greater than, or equal to, the recommended relia-bility p = 1 – q, it is necessary and suffi cient that the damage frequency sum qᵢ of decisive members is smaller than the admissible damage frequency q of thestructure: ∑qᵢ < q. On the basis of this theorem, s coeffi cients that recommend increase of the load bearing capacity of the decisive bars in a statically determinate structure constructed in order to meet the recommended class [9] of the structure reliability, are estimated and presented in a tabular form.
Field investigations concerning screw piles and columns have been carried out for the “Bearing capacity and work in the soil of screw piles” research project, financed by the Polish Ministry of Science and Higher Education – project No N N506 369234. The tests of three instrumented screw piles were conducted together with CPTU tests and measurements of pile installation parameters (especially torque). The objectives of field investigations and the entire research project include discovering how screw piles work in the soil, locating and describing the correlations between CPTU results and rotation resistance during pile auger installation and next establishing correlations between CPTU results, rotation resistance and the bearing capacity of this kind of piles. The paper describes the investigation procedure and the basic results of tests carried out in the first of a series of sites.
This article presents results of the numerical analysis of the interaction between heavy caterpillar tracks system and subsoil. The main goal of the article is to present an algorithm to design working platforms - temporary structures enabling the work of heavy construction equipment on weak subsoils. A semi-analytical method is based on the results of the numerical analysis performed with use of the finite element method (FE software ZSoil.PC [12]). The calculations were carried out for the piling rig machine - Bauer BH20H (BT60). Three ground models were adopted: Model 1: one layer - weak cohesive soil (clay); Model 2: two layers: weak cohesive soil (clay) and cohesionless working platform (medium sand); Model 3: one layer: strong cohesionless subsoil (medium sand). The following problems were solved: I) entry of the machine on the ground with various geotechnical parameters under each caterpillar tracks II) detection of the maximum permissible angle of ground slope.
Natural airfield pavements divide into soil and turf pavements. Turf pavement is a soil pavement covered with a developed grass layer that reduce soil moisture level, thus increasing its' resistance and extending exploitation period. Natural airfield pavements are formed through appropriate ground preparation. This pavement should be constructed in such a way as to have sufficient load-bearing capacity, which directly affects the safety of flight operations by aircraft. The current research indicates that a significant part of natural airfield pavements in Poland does not meet the requirements for load bearing capacity and require reinforcing. The article provides an example of reinforcing the natural airfield pavement with a system of geogrids. The paper describes what research was performed in order to measure the load-bearing capacity of natural airfield pavements and analyses the obtained results.