This paper discusses the configuration of a space-effective rack cell for storing a given set of heterogeneous items. Rack cells are the primary components of rack storage areas. A rack cell configuration problem (RCCP) for heterogeneous storage is formulated as a combinatorial mathematical model. An effective heuristic for solving the RCCP in practical cases is presented. The proposed heuristic consists of multistage brute force searching of defined sets of feasible solutions and solving linear integer assignment problems by the branch-and-bound method. The developed algorithm was implemented and tested, and the rack cell obtained meets the modularity requirements in the design and operation of heterogeneous storage areas.
This article presents the results of scientific investigations on the thermal regeneration process of a sorbent of mineral origin sorbent using a retort burner. Diesel oil, a petroleum liquid, most often pervades the environment during different catastrophes. The investigated sorbent of mineral origin was used in the standard way that the Fire Service removes such petroleum liquids from the environment during disasters. For research purposes, a regeneration chamber with a retort burner was constructed. The first phase of the investigation was aimed at defining the physico-chemical features of the sorbent after subsequent cycles of the regeneration process. The second phase involved an analysis of the energy and ecological effects of the regeneration process. The results showed that the first three cycles of the regeneration process occurred under low emission conditions. The proposed regeneration method achieved a positive energetic effect with a functional heat stream with an average value of 12.4 kW (average efficiency of the regeneration chamber was 68 %). The method is very efficient, with regeneration rates between 7.2 kg/h and 8.4 kg/h. It requires only a short amount of time for the start-up and extinction of the regeneration chamber, and it is also flexible to changes in the process conditions.
In this research, the high arsenic content dust of copper smelting, as a raw material, the extraction of copper and arsenic from the high arsenic content dust in the leaching system containing acidic and alkaline compounds was investigated. Meanwhile, the effects of acid/alkaline initial concentration, liquid to solid ratio, leaching temperature, leaching time on the leaching rate of copper and arsenic were studied. The optimum conditions for the leaching of high arsenic content dust and preparation of copper arsenate were determined. The results showed that acidic/alkaline leaching of high arsenic content dust was particularly effective. 93.2% of the copper, and 91.6% of the arsenic were leached in an acidic leaching process and 95% of the arsenic, while less than 3% of the copper, less than 5% of the antimony, less than 2% of the bismuth was also leached in an alkaline leaching process. A new method (the parallel flow drop precipitate method) was developed in the synthesis of copper arsenate process. The parallel flow drop method was employed to adjust the molar ratio (copper to arsenic) of the mixed solution of the acid-leaching solution and the alkali-leaching solution by taking the drop acceleration of an acidic leaching solution and an alkaline leaching solution at 10 mL/min and 12 mL/min, at a temperature of 60°C and a reaction time of 1 h. Copper arsenate was prepared by mixing an acidic leaching solution and an alkaline leaching solution. The main phases of copper arsenate were CuHAsO4·1.5H2O and Cu5As4O15·9H2O. Copper arsenate contained 30.13% copper and 31.10% arsenic.