The work contains a description of a developed experimental and theoretical method of modeling of solid waste combustion in a device equipped with a moving grate and capability to optimize the work of waste incineration plant. Implementation of this issue was based on results of experimental studies made on a laboratory scale boiler. This was possible by defining and testing indicators of quantitative assessment of combustion such as: reaction front rate, ignition rate, the rate of combusted mass loss and the heat release rate. These indicators as measurable "criteria indicators" allow transfer of parameters from a laboratory-scale unit, working in the transient regime into an industrial full scale grate device working continuously in stable determined conditions. This allows for wide optimization possibilities in the operation of a waste incineration plant, in particular the combustion chamber, equipped with a moving grate system.

The engine simulations have become an integral part of engine design and development. They are based on approximations and assumptions. The precision of the results depends on the accuracy of these hypotheses. The simplified models of frozen composition, chemical equilibrium and chemical kinetics provide the compositions of combustion products for engine cycle simulations. This paper evaluates the effects of different operating conditions and hypotheses on the exergetic analysis of a spark-ignition engine. The Brazilian automotive market has the highest number of flex-fuel vehicles. Therefore, a flex-fuel engine is considered for simulations in order to demonstrate the effects of these different hypotheses. The stroke length and bore diameter have the same value of 80 mm. The in-cylinder irreversibility is calculated for each case at the closed part of the engine cycle. A comparative analysis of these hypotheses provides a comprehensive evaluation of their effects on exergetic analysis. Higher values of accumulated irreversibility are observed for the oversimplified hypothesis.

A forecast of the negative impact exerted on the environment by selected trace elements in “Bełchatów” Power Plant has been prepared on the basis of the results of investigations into these elements’ distribution carried out as part of earlier research on coal from “Bełchatów” Field and the data on updated analyses of the content of these elements in 55 brown coal samples from test boreholes. Work in “Bełchatów” Power Plant, which is supplied with coal from “Szczerców” Field, will be accompanied by trace elements transfer. On the basis of the conducted investigations it has been found that the biosphere is most threatened by mercury emissions. As shown by the presented results of analyses and calculations, the emissions of mercury in “Bełchatów” Power Plant are low. Mercury is accumulated chiefl y in gypsum produced in the FGD plant. The content of mercury in slag and ash is low.