In this paper, an experimental surface roughness analysis in milling of tungsten carbide using a monolithic torus cubic boron nitride (CBN) tool is presented. The tungsten carbide was received using direct laser deposition technology (DLD). The depth of cut (ap), feed per tooth (fz) and tool wear (VBc) influence on surface roughness parameters (Ra, Rz) were investigated. The cutting forces and accelerations of vibrations were measured in order to estimate their quantitative influence on Ra and Rz parameters. The surface roughness analysis, from the point of view of milling dynamics was carried out. The dominative factor in the research was not feed per tooth fz (according to a theoretical model) but dynamical phenomena and feed per revolution f connected with them.

In view of their advantageous properties (high hardness, good frictional wear resistance, chemical and thermal stability at elevated temperatures), cubic boron nitride (cBN) and tungsten carbide (WC) are commonly used for the fabrication of cutting tools. The composites were consolidated at a temperature of 1100°C under a load of 100 MPa for 10 min. The density of the thus produced material was close to the theoretical value (about 99.6%), and the hardness HV30 was about 1950. The phases identified in the composite were WC, Co, and cBN. Microstructural examinations revealed that numerous trans-crystalline fractures through the cBN particles occurred in the material.

The present study is concerned with the wear of the WCCo and WCCo/cBN composites. Comparative tribological examinations were performed in a tribological tester using the ball-on-disc arrangement under the conditions of dry friction. The counterspecimens were steel and Al2O3 balls. The tests were conducted under a unit load of 10 N. After the tests, the surface of the samples was examined to describe the wear mechanisms active in various composite materials.