The study presents the analysis of the effects occurring at the propagation of electromagnetic waves within an area containing non-ideal, non-homogenous and absorbing dielectric. The analysed models are connected with housing constructions and include single and double-layered walls made of clay hollow bricks. The influence of the size of holes, the contained clay mass percentage and conductivity of brick on the distribution of electric field is presented. Double-layered wall causes more heterogeneity in distribution of electric field and numerous maxima and minima to compare with singlelayered construction. The presented results refer to the electromagnetic field generated by a wireless communication system (Wi-Fi), operating within the standard frequencies (2.4 GHz and 5 GHz). A FDTD method was used to the analysis of electric field distribution. Also in this paper all formulations of difference method (FDTD) is presented. The possibilities of modifying the described method are indicated too. The obtained values of electric field intensity allow to determining the attenuation coefficient for different variants of the walls. Detailed analysis of influence of different types of building construction will make it possible to better understand the wave phenomena and counteract local fading at planning of wireless networks systems.
In this attempt, Two Dimensional Photonic Crystal (2DPC) Quasi Square Ring Resonator (QSRR) based four channel demultiplexer is proposed and designed for Wavelength Division Multiplexing systems. The performance parameters of the demultiplexer such as transmission efficiency, passband width, line spacing, Q factor and crosstalk are investigated. The proposed demultiplexer is composed of bus waveguide, drop waveguide and QSRR. In the proposed demultiplexer, the output ports are arranged separately in odd and even number, where an odd number of ports are located on the right side and even number of ports are located on the left side of the bus waveguide that are used to reduce the channel interference or crosstalk. Further, the refractive index of rods around the center rod is increased linearly one to another in order to improve the signal quality. The resonant wavelengths of the proposed demultiplexer are of 1521.1 nm, 1522.0 nm, 1523.2 nm and 1524.3 nm, respectively. The footprint of the device is of 180.96 μm2. Then, a four channel point to point network is designed and the proposed four channel demultiplexer is implemented by replacing a conventional demultiplexer. Finally, functional parameters of the network, namely, BER, receiver sensitivity and Q factor are estimated by varying the link distance. This attempt could create new dimensions of research in the domain of photonic networks.
Recent years, the design of photonic crystal (PC) based optical devices is receiving keen interest in research and scientific community. In this paper, two dimensional (2D) PC based eight channel demultiplexer is proposed and designed and the functional characteristics of demultiplexer namely resonant wavelength, transmission efficiency, quality factor, spectral width, channel spacing and crosstalk are investigated. The demultiplexer is designed to drop the wavelength centred at 1537.6 nm, 1538.5 nm, 1539.4 nm, 1540.4 nm, 1541.2 nm, 1541.9 nm, 1542.6 nm and 1543.1 nm. The proposed demultiplexer is primarily composed of bus waveguide, drop waveguide and quasi square ring resonator. The quasi square ring resonator and square ring micro cavity (inner rods) are playing a vital role for a desired channel selection. The operating range of the devices is identified through a photonic band gap (PBG) which is obtained using a plane wave expansion (PWE) method. The functional characteristics of the proposed demultiplexer are attained using a 2D finite difference time domain (FDTD) method. The proposed device offers low crosstalk and high transmission efficiency with ultra-compact size, hence, it is highly desirable for DWDM applications.