It is well-known that the better the control of the liquid aluminium allows obtaining of better properties. One of the most important defects

that is held responsible for lower properties has been the presence of porosity. Porosity has always been associated with the amount of

dissolved hydrogen in the liquid. However, it was shown that hydrogen was not the major source but only a contributor the porosity. The

most important defect that causes porosity is the presence of bifilms. These defects are surface entrained mainly due to turbulence and

uncontrolled melt transfer. In this work, a cylindrical mould was designed (Ø30 x 300 mm) both from sand and die. Moulds were produced

both from sand and die. Water cooled copper chill was placed at the bottom of the mould in order to generate a directional solidification.

After the melt was prepared, prior to casting of the DC cast samples, reduced pressure test sample was taken to measure the melt quality

(i.e. bifilm index). The cast parts were then sectioned into regions and longitudinal and transverse areas were investigated

metallographically. Pore size, shape and distribution was measured by image analysis. The formation of porosity was evaluated by means

of bifilm content, size and distribution in A356 alloy.