In hot forging process, tool life is an important factor which influences the economy of production. Wear mechanisms in these processes are dependent on each other, so modeling of them is a difficult problem. The present research is focused on development of a hybrid tool wear model for hot forging processes and evaluation of adding adhesive mechanism component to this model. Although adhesive wear is dominant in cases, in which sliding distances are large, there is a group of hot forging processes, in which adhesion is an important factor in specific tool parts. In the paper, a proposed hybrid tool wear model has been described and various adhesive wear models have been reviewed. The feasible model has been chosen, adapted and implemented. It has been shown that adding adhesive wear model increases predictive capabilities of the global hybrid tool wear model as far as characteristic hot forging processes is considered.

This paper presents a review of models of the current transport in different kind of heterojunctions (HJs) and their characteristics. In order to effectively deduce the dominant electron transport for the HJs based on ZnO or Zn_1−xMg_xO layers grown on Si substrate by MBE a comparison is performed – which type of the HJ exhibits better electrical properties. The current–voltage characteristics for the studied HJs were measured within 280–300 K. The transport properties of the HJs are explained in terms of Anderson model with reference to aforementioned current transport models. It is found, that the mechanisms of current transport for all of the studied HJs are similar. At a low forward voltage bias the tunneling current dominates while at medium voltage bias (0.5–1 V) multitunneling capture-emission prevails with the electron trap located at 0.1–0.25 eV below the bottom of a ZnO (Zn_1−xMg_xO) conduction band. Beyond this voltage bias space charge limited current governs the current transport.

Hybryd PLD method was used for deposition high quality thin Ti, TiN, Ti(C,N) and DLC coatings. The kinetic energy of the evaporated particles was controlled by application of variation of different reactive and non reactive atmospheres during deposition. The purpose was to improve adhesion by building a bridge between the real ceramic coating and the substrate. A new layer composition layout was proposed by application of a buffer, starting layer. Advanced HRTEM investigation based on high resolution transmission electron microscopy was used to reveal structure dependence on specific atmosphere in the reactive chamber. New experimental technique to examine the crystallographic orientation based on X-ray texture tomography was applied to estimate contribution of the atmosphere to crystal orientation. Using Dictyostelium discoideum cells as a model organism for specific and nonspecific adhesion, kinetics of shear flow-induced cell detachment was studied. For a given cell, detachment occurs for critical stress values caused by the applied hydrodynamic pressure above a threshold. Cells are then removed from the substrate with an apparent first-order rate reaction that strongly depends on the stress. The threshold stress depends on cell size and physicochemical properties of the substrate, but it is not affected by depolymerization of the actin and tubulin cytoskeleton.