Search results

Filters

  • Journals
  • Authors
  • Keywords
  • Date
  • Type

Search results

Number of results: 13
items per page: 25 50 75
Sort by:
Download PDF Download RIS Download Bibtex

Abstract

The addition of hard ceramic particles of nc-(Ti,Mo)C in carbon network into Ti matrix has been proved to be an efficient way to enhance their properties. The purpose of this work was to analyze the corrosion, tribological, mechanical and morphological effects of combining nc-(Ti,Mo)C/C with titanium metal, to create a unique composite via selective laser melting technique (SLM). Composites with different weight percentage (5, 10 and 20 wt %) of ceramic phase were produced. The samples of pure Ti and Ti-6Al-4V alloy were also tested, as a reference. These composites were examined for corrosion resistance in body fluid (artificial saliva solution). Moreover, the properties of titanium composites reinforced with nc-TiC powders were compared. It was stated that mechanical properties were significantly improved with increasing amount of nc-(Ti,Mo)C/C in Ti matrix. In terms of corrosion resistance, the composites showed worse properties compared to pure titanium and Ti-6Al-4V alloy, but better than TiC-reinforced composites.

Go to article

Authors and Affiliations

P. Figiel
A. Biedunkiewicz
W. Biedunkiewicz
D. Grzesiak
M. Pawlyta
Download PDF Download RIS Download Bibtex

Abstract

The paper presents the issue of synthetic cast iron production in the electric induction furnace exclusively on the steel scrap base. Silicon

carbide and synthetic graphite were used as carburizers. The carburizers were introduced with solid charge or added on the liquid metal

surface. The chemical analysis of the produced cast iron, the carburization efficiency and microstructure features were presented in the

paper. It was stated that ferrosilicon can be replaced by silicon carbide during the synthetic cast iron melting process. However, due to its

chemical composition (30% C and 70% Si) which causes significant silicon content in iron increase, the carbon deficit can be partly

compensated by the carburizer introduction. Moreover it was shown that the best carbon and silicon assimilation rate is obtained where the

silicon carbide is being introduced together with solid charge. When it is thrown onto liquid alloy surface the efficiency of the process is

almost two times less and the melting process lasts dozen minutes long. The microstructure of the cast iron produced with the silicon

carbide shows more bulky graphite flakes than inside the microstructure of cast iron produced on the pig iron base.

Go to article

Authors and Affiliations

J. Szajnar
A. Stojczew
J. Jezierski
M. Pawlyta
K. Janerka
Download PDF Download RIS Download Bibtex

Abstract

The aim of these studies was to obtain single phase cubic modification of Li7La3Zr2O12 by mechanical milling and annealing of La(OH)3, Li2CO3 and ZrO2 powder mixture. Fritsch P5 planetary ball mill, Rigaku MiniFlex II X-ray diffractometer, Setaram TG-DSC 1500 analyser and FEI Titan 80-300 transmission electron microscope were used for sample preparation and investigations. The applied milling and annealing parameters allowed to obtain the significant contribution of c-Li7La3Zr2O12 in the sample structure, reaching 90%. Thermal measurements revealed more complex reactions requiring further studies.

Go to article

Authors and Affiliations

D. Oleszak
B. Kurowski
T. Pikula
M. Pawlyta
M. Senna
H. Suzuki

This page uses 'cookies'. Learn more