Ozonation is a heterogeneous process of chemical absorption often controlled by a gas-liquid mass transfer rate. This paper presents the results of kinetics in a reaction between phenylphenol isomers and ozone. The degradation of phenylphenol isomers during ozonation proceeds quite fast. In order to avoid the influence of mass transfer limitation the kinetics experiments were conducted in a homogenous liquid-liquid system. The second-order rate constants were determined using classical and competition methods, which are especially recommended for fast reactions. The determined rate constants at pH 2 using the two different methods are almost the same. The increase of pH causes an increase of rate constants for the reaction of phenylphenol isomers with ozone.

The aim of the paper is to present the hydrodynamic, mass transfer and illumination characteristics of a laboratory helical-tube photobioreactor Biostat PBR-2S, commercially available and used in many laboratories in Poland and worldwide. The investigated hydrodynamics parameters were: mean liquid circulation rate, liquid velocity/residence time in the tubular part of the apparatus and mixing time, measured in the wide range of rotary speed of the circulation pump. The influence of the aeration intensity on these parameters was also checked. The volumetric oxygen and carbon dioxide transfer coefficients in the liquid phase and their dependency on the liquid circulation rate and gas inflow rate were determined. The experiments were performed in tap water and then in a real three-phase cultivation broth at the end of thermophilic cyanobacteria T. synechococus growth. For the final evaluation of the tested PBR there were series of test cultivations run under different conditions of illumination. The highest final concentration of the biomass of tested cyanobacteria reached the relatively high value of 4.38 g/dm3 of the dry biomass, although the process conditions were not fully optimized. The laboratory photobioreactor PBR-2S proved to be a good tool for investigations of microalgae cultivation processes. The presented results and practical observations may help to analyze and understand the mutual influence of the specific process parameters in the described PBR, especially during autotrophic organism cultivations.

Biosynthesis of lovastatin (a polyketide metabolite of Aspergillus terreus) in bioreactors of different working volume was studied to indicate how the change of scale of the process influences the formation of this metabolite. The experiments conducted in shake flasks of 150 ml working volume allowed to obtain lovastatin titres at the level of 87.5 mg LOV l-1, when two carbon sources, namely lactose and glycerol were used. The application of the same components in a large stirred-tank bioreactor of 5.3-litre working volume caused a decrease of lovastatin production by 87% compared to the shake flask culture. The deficiency of nitrogen in this bioreactor did not favour the formation of lovastatin, in contrast to the small bioreactor of 1.95-litre working volume, in which lovastatin titres comparable to those in the shake flasks could be achieved, when organic nitrogen concentration was two-fold decreased. When the control of pH and/or pO2 was used simultaneously, an increase in lovastatin production was observed in the bioreactors. However, these results were still slightly lower than lovastatin titres obtained in the shake flasks.

A mathematical model of a plane, steady state biofilm, with the use of a single substrate kinetics, was proposed. A set of differential equations was solved. In order to analyse the biofilm’s behaviour, a number of simulations were performed. The simulations included varying process parameters such as detachment coefficient and substrate loading. Two detachment models were taken into consideration: one describing the detachment ratio as proportional to the thickness of the biofilm, and the other one proportional to the thickness of the biofilm squared. The results provided information about substrate and live cell distribution in biofilm and the influence of certain parameters on biofilm behaviour.

Surfactants after their use are discharged into aquatic ecosystems. These compounds may be harmful to fauna and flora in surface waters or can be toxic for microorganisms of the activated sludge or biofilm in WWTP. In order to determine effectiveness of different advanced oxidation processes on the degradation of surfactants, in this study the degradation of anionic surfactants in aqueous solution using photolysis by 254 nm irradiation and by advanced oxidation process in a H2O2/UVC system was investigated. Two representatives of anionic surfactants, linear alkyl benzene sulphonate (LAS-R11–14) and ether carboxylic derivate (EC-R12–14E10) were tested. The influence of pH, initial surfactant concentration and dose of hydrogen peroxide on the degradation was also studied. Results show outstanding effectiveness of the H2O2/UVC system in the removal of surfactant from aqueous solutions.

The world in 21st century is facing the problem of growing energy consumption while the supply of fossil fuels is being reduced. This resulted in the development of research into the use of renewable energy sources and development of new technologies for energy production. In Polish conditions the development of agricultural biogas plants finds its legitimacy in the document developed by the Ministry titled "Trends in agricultural biogas plants in Poland in 2010-2020”. The purpose of this study was to investigate the influence of the weather conditions and the degree of nitrogen fertilisation on yield of reed canary grass (Phalaris Arundinacea L.) and to determine their susceptibility to anaerobic digestion, and usefulness of the production of biogas. Carried out experiments showed that increasing nitrogen fertilisation (from 40 to 120 kg N/ha) linearly increased canary grass green biomass yield from 32 to 46.3 t/ha. However, the highest biogas yield 126 m3/ha was obtained when 80 kg N/ha was applied.

Foam fractionation process for concentration of laccases from two Basidiomycete strains under different process conditions was investigated. Culture supernatants of Cerrena unicolor and Pleurotus sapidus containing active laccase were used with and without surfactant additives. Two surfactants: cationic cetrimonium bromide (CTAB) and non-ionic Polysorbate 80 were applied in the range from 0.2 mM to 1.5 mM. The pH levels ranging from 3 to 10 were examined with particular attention to pH=4, which is close to the pI of the enzymes. Results show that the source of the enzyme is significant in terms of partitioning efficiency in a foam fractionation process. Laccase from Cerrena unicolor showed the best activity partitioning coefficients between foamate and retentate of almost 200 with yields reaching 50% for pH 7.5 and concentration of CTAB cCTAB = 0.5 mM, whereas laccase from Pleurotus sapidus showed partitioning coefficients of up to 8 with 25% yield for pH 4 and cCTAB = 0.5 mM.

Culture supernatant containing laccase produced by Cerrena unicolor strain was used to examine laccase partitioning between phases in an aqueous two-phase system. The investigated system consisted of polyethylene glycol 3000 and sodium phosphate buffer adjusted to pH = 7. Influence of several parameters on partitioning was measured, including phase forming components’ concentrations, tie line lengths, phase volume ratio, supernatant dilution, process temperature and halogen salt supplementation. Partitioning coefficients up to 78 in the bottom phase were achieved with yields of over 90%. Tie line length and phase volume ratio had significant effect on enzyme partitioning.

The results of activity studies of four catalysts in methanol synthesis have been presented. A standard industrial catalyst TMC-3/1 was compared with two methanol catalysts promoted by the addition of magnesium and one promoted by zirconium. The kinetic analysis of the experimental results shows that the Cu/Zn/Al/Mg/1 catalyst was the least active. Although TMC-3/1 and Cu/Zn/Al/Mg/2 catalysts were characterised by a higher activity, the most active catalyst system was Cu/Zn/Al/Zr. The activity calculated for zirconium doped catalyst under operating conditions was approximately 30% higher that of TMC-3/1catalyst. The experimental data were used to identify the rate equations of two types - one purely empirical power rate equation and the other one - the Vanden Bussche & Froment kinetic model of methanol synthesis. The Cu/ZnO/Al2O3 catalyst modified with zirconium has the highest application potential in methanol synthesis.