Due to the wide range of various sheet metal grades and the need to verify the material properties, there are numerous methods to determine the material formability. One of them, that allows quick determination of sheet metal formability, is the Erichsen cupping test described in the ISO 20482: 2003 standard. In the presented work, the results of formability assessment for DC04 deep drawing sheet metal were obtained by means of the traditionally carried out Erichsen cupping test and compared with the results obtained by using two advanced methods based on vision analysis. Application of these methods allows extending the traditional scope of analysis during Erichsen cupping test by determination of the necking and strain localization before fracture. The proposed methods were compared in order to dedicate appropriate solution for the industrial application and laboratory tests respectively, where the simplicity and reliability are the mean aspects need to be considered when applied to the Erichsen cupping test.

The paper presents a method of measuring deformations of cylindrical samples on the testing machine for free tube hydroforming experiments. During experiments a sample made of a thin-walled metal tube is expanded by the internal pressure of the working liquid and additionally subjected to axial compression. This results in a considerable circumferential deformation of the tube and its shortening. Analysis of the load cases and their impact on the deformations can be helpful in determining e.g. tube material properties or general limiting conditions in the tube hydroforming process. In connection with the above, the value of deformations and knowledge of their course during experiment has become one of the most important problems related to the issue described above.

Advanced vision method of analysis of the Erichsen cupping test based on laser speckle is presented in this work. This method proved to be useful for expanding the range of information on material formability for two commonly used grades of steel sheets: DC04 and DC01. The authors present a complex methodology and experimental procedure that allows not only to determine the standard Erichsen index but also to follow the material deformation stages immediately preceding the occurrence of the crack. Accurate determination of these characteristics in the sheet metal forming would be an important application, especially for automotive industry. However, the sheet metal forming is a very complex manufacturing process and its success depends on many factors. Therefore, attention is focused in this study on better understanding of the Erichsen index in combination with the material deformation history.