The aim of the work was to obtain thin bismuth oxide films containing, at room temperature, the Bi1,5Er0,5O3 phase. This phase corresponds to the structure of the high-temperature δ-Bi2O3 phase, in pure bismuth oxide, characterized by the highest ionic conductivity of all known solid state ionic conductors. The high-temperature δ-Bi2O3 phase with the face centered cubic structure, in pure bismuth oxide, occurs only at temperature above 730°C.

Stabilization of the δ-Bi2O3 phase at room temperature was achieved by an addition of the erbium together with the employment of the Pulsed Laser Deposition (PLD) technique. The influence of an amount of Er alloying and the film thickness on surface morphology, microstructure, phase composition of thin films were investigated. The velocity of deposition of thin layers of bismuth stabilized with erbium in the PLD process using the Nd: YAG laser was about 0.5 nm/s.

The investigation results of erbium doped bismuth oxide thin films deposited onto (0001) oriented Al2O3 monocrystalline substrate are presented.

Thin films of uniform thickness, without cracks, and porosity were obtained. All deposited thin films (regardless of the film thickness or erbia (Er2O3) content) exhibited a columnar structure. In films stabilized with erbium, up to approx. 250 nm thickness, the columns have a diameter at the base from 25 to 75 nm. The columns densely and tightly fill the entire volume of the films. With increasing of the film thickness increases, porosity also significantly increases. In thin layers containing from 20 to 30 mole % Er2O3 the main identified phase at room temperature is Bi1.5Er0.5O3. It is similar to the defective fluorite-type structure, and belongs to the Fm-3m space group. This phase corresponds to the structure of the high-temperature δ-Bi2O3 phase in pure bismuth oxide.

The aim of this work was to characterize the changes in microstructure and chemical composition of the austenitic overlays on a pressure vessel steel that occur in the vicinity of the interface between the overlay and the base material. The investigations were carried out on a 16Mo3 boiler pipes weld overlaid by 309 and 310 steels. The microstructural examinations were performed on longitudinal cross-sectioned samples. The qualitative and quantitative chemical composition analyses on metallographic samples were determined on Scanning Electron Microscopy (SEM) by means of Energy Dispersive Spectrometry (EDS). The article analyzes the influence of the solidification sequence in both types of steel on final microstructure.

Thin films of crystallized LaCoO3 were grown on Si substrate by Pulsed Laser Deposition at different temperatures (750°C, 850°C and 1000°C). The structural characterization of the LaCoO3 thin films was done by combining several techniques: Scanning Electron Microscopy (SEM), Atomic Force Microscope (AFM), Transmission Electron Microscopy (TEM) and Grazing Incidence X-Ray Diffraction (GIXRD). The thin films crystallized in the expected rhombohedral phase whatever the deposition temperature, with an increase of crystallite size from 70 nm at 750°C to 100 nm at 1000°C, and an average thickness of the thin films of less than 200 nm. At 850°C and 1000°C, the thin films are crack-free, and with a lower number of droplets than the film deposited at 750°C. The grains of LaCoO3 film deposited at 850°C are columnar, with a triangular termination. At 1000°C, an intermediate layer of La2Si2O7 was observed, indicating diffusion of Si into the deposited film.