Circuit Breakers (CBs) play an important role in ensuring the safe operation of protection systems. Condition Monitoring (CM) devices are widely implemented to extend lifetime, and to improve the maintenance quality. The present paper proposes a cost-based prioritization approach for CBs in a network equipped withCMdevices. To this end, a mathematical formulation is developed for the categorization and modeling of equipment failures based on their severity. This formulation quantifies the effect of the CM devices on the outage rate of the equipment. The reliability parameters of the substations 400/132/20 KV, including the failure rate, λ, average repair time, r, average outage time, U, substations, in two status of without CM and with CM of the CBs are calculated. These parameters are calculated implementing a minimal cut-set method. The outage rate of equipment with and without the CM devices is used to determine the effect of the CM devices on the reliability of the network. Finally, the prioritization of substations to install theCMdevices on the CBs has been investigated in terms of the Expected Energy Not Supplied (EENS) and costs of CM. To verify the effectiveness and applicability of the method, the proposed approach is applied to the CBs in the power transmission network in the Khorasan Regional Electricity Company (KREC) in Iran.

Wind turbines are among the key equipment needed for eco-friendly generation of electricity. Maintaining wind turbines in excellent technical condition is extremely important not only for safety but also for efficient operation. Studies indicate that defects in the external structure of a turbine blade reduce energy production efficiency. This research investigated the potential of the terrestrial laser scanning technology to examine the technical conditions of wind turbine blades. The main aim of the study was to examine whether terrestrial laser scanning measurements can be valuable for wind turbine blade condition surveying. The investigation was based on the radiometric analyses of point clouds, which forms the novelty of the present study. Condition monitoring focuses on the detection of defects, such as cracks, cavities, or signs of erosion. Moreover, this study consisted of two stages. The next objective entailed the development and examination of two different measurement methods. It was then identified which method is more advantageous by analysing their effectiveness and other economic considerations.