The subject of this study was Rhizopertha dominica F. population. The primary question referred to was the process of the lesser grain borer population spread depending on nutritional preferences of this species. The aim of performed laboratory experiments was to examine the adults’ ability to choose preferred kinds of food i conditions of free migration among them and to analyze the dynamics of population size. Sex ratio and the migration rate were also analyzed. Four types of food were used during the experiments: wheat, oat flakes, pearl barley and semolina. The experiments were conducted at 28°C and 60 ± 5% of relative humidity. Results of the study revealed that oat flakes were the most favourable nutriment for adult R. dominica whereas wheat grain was the most favourable for the population size since larvae were protected by grains and thus their increased number could survive. No population development in semolina was observed. It was the result of too small granulation of this food.

The article presents tests carried out on three selected samples of limestone originating from three commercially exploited deposits. The tests of sorbents included desulphurisation in different atmospheres and a physicochemical analysis of desulphurisation products. The aim of the tests was to determine desulphurisation efficiency and conversion degree as dependent on the concentration of O2 and CO2.

One of the main problems of electrical power quality is to ensure a constant power ?ux from the supply system to the receiver, keeping in the same time the undisturbed wave form of the current and voltage signals. Distortion of signals are caused by nonlinear or time varying receivers, voltage changes or power losses in a supply system. The wave-form of the voltage of the source may also be deformed. This study seeks the optimal current and voltage wave-form by means of an optimization criteria. The optimization problem is de?ned in Hilbert space and the special functionals are minimized. The source inner impedance operator is linear and time-varying. Some examples of calculations are presented.