This work is a contribution to a normative approach of noise assessment in the professional environment. It permits the identification of the affected workstations on the one hand and on the other hand it constitutes an important support to the preoccupations of the impact study on the environment in plants. It also informs us on the adequate preparation of the procedures required by the Environmental Management System (ISO 14001) being implemented in steel-making complex ArcelorMittal Algeria. It constitutes an answer to the recommended environmental politics. The proposed calculation methods are verified according to the recognized sources (ISO 9612, 2009) and the results will be estimated in relation to the legal thresholds recommended by international bodies. The methodology for measuring the noise exposure levels has been done according to the following steps: work analysis; selection of measurement strategy; measurements; error handling and uncertainty evaluations; calculations; and presentation of results. This will lead us to an implementation of a corrective and preventive action plan intended to master this occupational risk carrying prejudice to the health of the workers.

The molecular dynamics of the well-known nematic liquid crystal 4-n-pentyl-4′-cyanobiphenyl geometrically restricted in Anopore and Synpor porous membranes with various pore structure and treated by different surfactants (namely decanoic acid and lecithin) is compared. In the Anopore membrane the chosen surfactants induce the homeotropic orientation of the molecules on the walls of the cylindrical pores and observed corresponding relaxation processes (librational modes) are practically the same. The dielectric measurements of lecithin treated Synpor membranes reveals the reorientation of the molecules from planar to homeotropic on the complex multilayer structure present in their volume. The dielectric strengths of the observed two molecular processes (δ-process and librational mode) are inversed in the ratio compared to the untreated membranes. The observed differences in molecular dynamics results from the orientation of the liquid crystal molecules in untreated and treated membranes and the structure of the membranes themselves.

17-4PH stainless steel finds application in the aerospace industry owing to its good mechanical properties and corrosion resistance. In the literature, this steel is described as good for welding, but research shows that it may be problematic due to the formation of defects. In this study, the welded joints were made by the robotic TIG welding method with various welding speeds (2 and 3 mm/s). The joints were subjected to non-destructive testing and were free from defects. The microstructure was observed by light microscopy and scanning electron microscopy. Changes in the microstructure of the heat affected zone were observed and discussed. Based on the observation of the microstructure and the change in the hardness profile, the heat affected zone was divided into 4 characteristic regions. δ-ferrite and NbC were observed in the martensite matrix. The welded joints were subjected to heat treatment consisting of solution and aging in 550°C for 4 h. The microstructure of the heat affected zone become homogenized as a result of the heat treatment. The content of stable austenite in the welded joint after the heat treatment was about 3%.

The purpose of the work was to determine the infuence of the bulk density ρz of granules, processing parameters and the density of ski inserts ρw made of expanded polystyrene (EPS) on their damping properties. For this aim liners for ski helmets with 3 different bulk densities were made. Sintering time and sintering pressure were also changed. The percentage damping factor η was determined on the basis of the results obtained in the rebound resilience test. Based on the analysis of the obtained data, it was found that increasing the density of EPS pads ρw increases their damping properties and at the same time contributes to a decrease in elasticity, increase in hardness and brittleness of EPS products.