TY - JOUR N2 - The paper presents research results on the selection of parameters for the asymmetric rolling process of bimetallic plates 10CrMo9-10 + X2CrNiMo17-12-2. They consisted in determining the optimum parameters of the process, which would be ensured to obtain straight bands. Such deformation method introduces in the band the deformations resulting from shear stress, which affect changes in the microstructure. But their effect on the structure is more complicated than in the case of homogeneous materials. It has been shown that the introduction of asymmetric conditions into the rolling process results in greater grain refinement in the so-called hard layer. There was no negative effect on the structural changes in the soft layer observed. L1 - http://www.czasopisma.pan.pl/Content/113606/PDF/AMM-2019-4-37-Rydz.pdf L2 - http://www.czasopisma.pan.pl/Content/113606 PY - 2019 IS - No 4 EP - 1501 DO - 10.24425/amm.2019.130118 KW - asymmetric rolling KW - microstructure KW - plastic deformation A1 - Rydz, D. A1 - Koczurkiewicz, B. A1 - Stradomski, G. A1 - Garstka, T. A1 - Wypart, J. PB - Institute of Metallurgy and Materials Science of Polish Academy of Sciences PB - Committee of Materials Engineering and Metallurgy of Polish Academy of Sciences VL - vol. 64 DA - 2019.12.12 T1 - The Effect of the Asymmetrical Rolling Process on Structural Changes in Hot-Rolled Bimetal Sheets SP - 1495 UR - http://www.czasopisma.pan.pl/dlibra/publication/edition/113606 T2 - Archives of Metallurgy and Materials ER -